Your wardrobe, made to measure.
Choose the shape, the dimensions and every detail. The drawing updates as you make your choices. The quote is prepared after we have reviewed the project.
Measurements and type
Enter the measurements and shape of your wardrobe
How to complete this step
In a few minutes you will have your wardrobe drawn up and ready to request a quote. There is no need to be exact: we take the final measurements at your home before anything is made.
- Choose the shape that most closely matches your space.
- Say whether the wardrobe is fitted into an alcove or freestanding.
- Enter the width, height and depth in millimetres (300 cm = 3000 mm). You can also type «240 cm» or «2.4 m».
- Move on to the next step: you can go back whenever you like without losing anything.
Frequently asked questions
- How do I measure?
- Measure the width at three points (bottom, middle and top) and the height on the left and on the right, then use the smallest measurement. The depth runs from the back wall to where you want the front of the wardrobe to sit.
- What if I don’t have exact measurements?
- Enter approximate measurements: they are fine for the design and a first idea of cost. We take the final ones at your home, before manufacture.
- Which shape should I choose?
- Straight: along a single wall. Under-stairs or Sloping ceiling: the height changes from one side to the other. Corner / L-shaped or U-shaped: takes up two or three walls. Other shape: you describe it and we look at it with you.
- Fitted or freestanding?
- Fitted: goes between walls; you give the measurements of the alcove and we allow for gaps and trims. Freestanding: the sides are visible; you give the outside measurements of the wardrobe.
- What depth do I need?
- For hanging clothes on hangers, 600 mm is typical. Under the «Depth» field you will see the minimum for hanging with the doors you have chosen.
- How do I enter a sloping ceiling or an under-stairs space?
- Enter the height on the left and on the right, as seen from the front; one of the two can be 0. «Swap sides» switches them over.
These measurements are a starting point. Enter your own or confirm that they match your space.
Measurements
From side to side, along the front. In mm: 300 cm = 3000 mm.
From the floor to the ceiling or to the top of the wardrobe.
From the front to the back wall.To hang clothes with sliding: minimum depth 596 mm.
3 sections · 3,000 mm
Special features (optional)
Example values: change them to your own measurements.
Would you rather we went through it with you? Tell us about your project.
Step by step: from the space to the design
You start with the width, height and depth of the space. If the opening varies between different points, note down the smallest and largest measurements so you can mention them when you send the design. Then you choose the type of wardrobe, the door opening style and the interior layout, and finish with the finishes and accessories. The seven steps are in an order that lets you move forward without skipping a single decision.

Organise sections, interior and doors
Arrange the hanging areas, shelves and drawers to suit your clothes. Then see how they fit with the doors. If an option appears greyed out, it won't fit in the combination you've chosen. Keep your real measurements and tell us which alternative you'd prefer rather than changing figures to unlock it.
Have you already measured the space?
Send us a photo and the approximate measurements on WhatsApp and we'll give you some initial guidance.
Choose a first idea for the finish
The textures and colours on screen are a guide, and the real shade may vary slightly from the samples. The range available is wider than what you see here. During the measuring visit we go through samples with you and agree the finish, profiles and handles for the project.
Accessories and where they go
Tick the accessories you're interested in. We fine-tune their exact position along with the interior layout and the swing of the doors and pull-out units. If there's something you can't find, tell our team in your message: with your measurements, we'll look at how to include it.
Zoom in and check the diagram
The zoom option lets you see the front or the interior in more detail. Check what has been assigned to each module and whether the drawing reflects what you have in mind. The clothes and accessories shown are for illustration only. Anything that isn't clear, explain in the message when you send the project.

Send your design and get your quote in Valencia
Add your town, photos and any comments you'd like. The configurator prepares a WhatsApp message with your design, which you can review before pressing send. With it, we pin down materials, measurements and scope, and draw up the quote once the space has been measured. We cover Valencia and its province.
Questions
Frequently asked questions about wardrobes in Valencia
Is the diagram a manufacturing plan?
It's a representation to help you prepare and share your idea. Manufacturing measurements are taken on site, during the measuring visit.
What if my layout isn't shown?
Send us a sketch and tell us the shape you're after. There's no need to force an option that doesn't suit your space.
Does the configurator give me a price?
It doesn't show any prices. We draw up the quote ourselves, based on your design, the real measurements and the finishes you've chosen.
Do I have to send the design to try out options?
No. You can try as many combinations as you like and only send it when you're happy with it.
Your idea is the first step.
Would you like us to go over your wardrobe with you? Tell us what you need and we'll agree the details during the visit.
If you've already put your design together, use "Send project via WhatsApp" in the configurator to share your selections.